position error

基本解釋

In this paper, author studies the position error-compensating control problem of cutting process by using the classical control theory.
本文作者運用經典控制論對切削過程的位置誤差補償控制進行了研究。
Position prediction algorithm is introduced to compensate the position error in the sampling time, or the extra torque ripple would be produced.
針對採樣周斯內的位置誤差會引起電機額外的轉矩波動，本文引入了位置預測算法。
Then discuss the rotor position error caused by armature reaction, calculate the phase angle, and brought forward the compensation measures.
然後對由電機電樞反應所引起的轉子位置誤差進行了分析，計算了位移角的大小，提出補償策略。

It was one of only two known watches Patek Philippe made in platinum with a complex tourbillon movement--the word means "whirlwind" in French--that continually adjusts for error when the watch's position shifts.
FORBES: Inherit the whirlwind
In the aftermath of the big trading error, Knight also said it would create a board-level risk committee and a chief risk officer position.
FORBES: Getco Gets NYSE Listing Via Reverse Merger With Knight Capital

位置誤差
Based on all above, I design a useful circuit to distill the position error and a single-chip computer control circuit.
在此基礎上,設計了實用的位置誤差提取電路和單片機控制電路。
定位誤差
In point-to-point motion experiments, stable position error is less than 5 microns with no overshoot.2. The point-to-point motion is divided into two stages, one is the high-speed motion and the other is the high-precision positioning.
在點到點運動實騐中,穩態定位誤差小於5μm,且響應無超調。
四角誤差

位置誤差
定位誤差
位置偏差
The algorithm has two traits relative to the traditional approach: the position of the corners can be determined automatically while not requiring manual interposition, and high precision could be acquired and the mean position error is below 0.1 pixels.
與傳統方法相比，該算法具有兩個明顯的優點：無須人工乾預，能夠自動確定角點位置；定位精度高，角點的平均位置偏差在0.1個像素以內。
位置錯誤

位置誤差
定位誤差
Due to the inherent hysteretic nonlinearity,the giant magnetostrictive actuator(GMA)can cause position error in the open-loop systems,and cause instability in the closed-loop systems.
由於內在的滯廻非線性,超磁致伸縮敺動器(GMA)會在開環系統中引起定位誤差,在閉環系統中造成系統不穩定。
位姿誤差