gaugemeter

基本解釋

The creating of target gauge control model based on the setpoint of the exit thickness gaugemeter is discussed in this paper.
本文以軋機出口側測厚儀目標厚度設定值爲基準點，建立目標控制模型。
This paper introduces aluminum mill stand control system with cylinder device.It mainly includes load control,gap control and gaugemeter control that are closed loop control.
本文介紹了鋁箔軋機過程控制系統(系統)中的關於液壓缸控制的機架控制系統,主要分析了其中的軋制力控制、輥縫控制、厚度計控制。
New gaugemeter type variable stiff ness control system
厚度計型變剛度控制系統研究
Verification of the Uniformity of Gaugemeter Type and Dynamic Set Type Mill Modulus Control System
厚度計型和動態設定型變剛度系統的統一性証明