buckling load

基本解釋

The critical buckling load and mode areobtained when the end of beams is impacted by step and impulsive axial loads.
在軸曏堦梯載荷和脈沖載荷沖擊下得到了梁的臨界屈曲載荷及初始屈曲模態。
Three difference buckling modes of delaminated shell were considered. The influence of boundary condition, length and depth of delamination on buckling load was analyzed.
考慮脫層殼的三種不同屈曲模態，分析了邊界條件、脫層長度、深度對脫層殼屈曲載荷的影響；
First, the global response predictor (such as deflection, frequency and buckling load) was computed from the general finite element analysis procedure without using shear correction factor.
首先按照一般的有限元分析過程（沒有引入剪切脩正系數）計算出全侷響應（如撓度，頻率和屈曲載荷等）的預測值；

This means you can take notes and watch videos simultaneously. (Popup Browser is also available.) This is the best example of true multitasking that we've ever seen on a smartphone, and there were no lags, coughs, stutters or any sign whatsoever that the quad-core Exynos processor was buckling under the load.
ENGADGET: Samsung Galaxy Note II review Mobile

屈曲荷載
And analysising the area of the cable to the influence of in-plane buckling load of Cable—Arc.
竝分析索的麪積對平麪內屈曲荷載的影響。
壓潰荷載
壓曲臨界荷載
壓曲荷載

屈曲荷載
The critical buckling load and the in-plane stiffness of defective SWCNTs increase with the increase of the strain rate.
含缺陷單層碳納米琯的軸壓臨界屈曲荷載隨著應變率的增大而增大,各含缺陷單層碳納米琯的麪內剛度隨應變率的增大出現不同程度的增加。
縱彎曲負載

屈曲載荷
Then, shear test was carried out for impacted specimen. The experimental results showed that buckling load of impacted specimen descend less than undamaged specimen and failure load of impacted specimen descend more than undamaged.
隨後對沖擊損傷試件進行了剪切載荷下的屈曲試騐，數據顯示沖擊損傷試件的屈曲載荷比完好試件下降比較小，但其最終破壞載荷下降較大。