static load test

基本解釋

In the engineering practice the method of static load test is usually used to evaluate the capacity and working status of the existing structure.
工程實踐中常常采用靜載試驗的方法評定既有結構的承載能力及工作狀態。
The compression of the pile in the pile group can be determined by static load test. The settlement of the pile toe is calculated by layer wise summation method.
群樁中樁身壓縮由單樁靜載試驗得到的樁頂沉降與樁端沉降之差求得，群樁的樁端沉降由分層總和法計算。
In this article, the author analyzes the causes of abnormal static load test of pipe pile in soft soil stratum, puts forward reasonable advices from design and construction aspect.
對軟土地質條件下管樁靜載荷試驗異常原因進行研究分析，從設計和施工角度提出了合理建議。

靜載試驗
Comparing with the static load test and high strain dynamic test, this method is cheaper and nondestructive. It can check all the piles of site and make up the deficiency of other methods.
與靜載試驗、大應變動力測樁方法相比具有成本顯著降低、效率高、無破損等特點，從而可實現現場基樁承載力的100％檢測，打破以往基樁承載力只能抽檢的局面。
靜載荷試驗
Comparing with the result of static load test, the regulative coefficient is received.
同時提出與場地靜載荷試驗結果進行對比，得到調整系數，提高預測精度。
靜荷載試驗

靜載試驗
Currently, the most accurate method of pile bearing capacity - settlement curve is static load test, but done a lot of static load test in advance is very difficult, so application in large scale is obviously unrealistic.
目前,公認的樁基承載力-沉降曲線最準確的辦法是靜載試驗,但提前做靜載試驗有諸多難處,大量推廣應用顯然是不現實的。
靜載荷試驗
The construction process and load-bearing characteristics of cast-in-situ concrete thin-wall pipe piles have been analyzed based on their application in soft soil improvement of Yan-Tong Expressway. The low strain test, static load test and excavation also have been performed in-situ.
結合現澆薄壁管樁在鹽通高速公路軟基加固中的應用,對管樁施工方法和承載特性進行了分析研究,并進行了小應變測試、靜載荷試驗和現場開挖等檢測分析。
靜載實驗