normal stress

基本解釋

The mode of the surface crack is open at beginning, that may be explained by the maximum normal stress theory.
結果表明，最初出現的表面裂紋是張開型的，其產生原因可以用最大拉應力理論來解釋。
The objective is to verify the predictions of engineering beam theory in so far as that theory defines the centerline deflection and extreme values of the normal stress.
實驗?zāi)康氖亲C明現行的工程梁理論，這種理論定義了中心線變形和普通應力的極值。
The drawing test results show that the shear strength of the interface is not proportional to the normal stress because of its dilatancy behavior due to shear application.
土工布拉拔試驗結果表明，由于土與土工織物接觸面的剪脹造成該類接觸面的抗剪強度與法向應力不再是線性關系；

Not only are they experiencing the normal stress of management but this imminent financial amputation is also pushing many to their limit.
FORBES: There's Nothing Like A Financial Crisis To Bring Out The Best In People

正應力
The relationship between the shear strength of bonding layer and its normal stress was expatiated under low hydrostatic stress-state.
并從破壞機理上分析了影響粘結層剪切強度的因素；及對低靜水應力狀態下，粘結層剪切強度與其上作用的正應力關系進行了闡述。
正向應力

正應力
The normal stress in column increases gradually with depth above the neutral depth z m and decreases gradually with depth below the neutral depth z m, also decreases with replacement rate.
樁體正應力值在中性點以上隨深度遞增,中性點以下隨深度遞減,并且樁體正應力值隨置換率的增加而減小。
能源科學技術
法向應力
The results showed that the higher concentration is, the bigger first normal stress difference is. It means that solution has higher elastic energy.
聚丙烯酰胺溶液的濃度越高,聚合物溶液的第一法向應力差越大,說明聚合物溶液具有的彈性能量越高。
物理學
正應力
法向應力
正力
正向應力