cyclic softening

基本解釋

The results show that the matrix in the microstructure occurs dynamic recovery and recrystallization and the materials generate cyclic softening during thermal cycling.
結果表明，在熱循環過程中基體組織發生動態回復和再結晶，材料產生循環軟化；
Its cyclic properties first show cyclic softening, after stabilizing, then cyclic hardening. The state of cyclic softening and cyclic hardening will vary along with strain level.
其循環相關特性表現為先循環軟化，穩定后又發生循環硬化，而且循環軟化和循環硬化的程度隨控制應變的不同而不同。
Based on the results of cyclic softening and cyclic creeping tests at room temperature, the resilient relaxation tendency of the most commonly used spring steels were discussed in the paper.
本文從循環軟化和循環蠕變兩個不同側面對常用彈簧鋼的彈性松弛趨勢進行了對比試驗研究并對它們的彈性松弛趨勢大小進行了初步評價。

循環軟化
The details are presented as follows. At different stress amplitudes (i. e. , HCF regime, LCF regime and in-between regime), cyclic softening occurs in each case, and this phenomenon takes place more significantly with increasing stress amplitude.
在不同應力幅和不同度溫度下其疲勞和損傷行為表現出明顯不同的特點,具體表現如下：在不同應力幅下(即：高周疲勞區、低周疲勞區和介于高低周疲勞區之間)均發生了循環軟化現象,而且隨著應力幅的增加循環軟化發生得更顯著。
機械工程
循環軟化
The experimental results show that the PTFE is a rate-dependent material. Cyclic softening is found to exist under pure torsion loadings, and the PTFE has noticeable non-Masing behavior.
實驗表明,PTFE是率相關材料,在剪切方向呈現循環軟化,并且有明顯的non-Masing特征。
物理學
循環軟化