cohesive zone model

基本解釋

The high requirement on the supervising equipment of blast furnace is needed in the cohesive zone model of Baogang.
寶鋼軟熔帶模型對高爐監測裝置要求較高；只有十字測溫裝置和爐身上部探測器正常時，模型才能正常運行。
The high requirement on the supervising equipment of blast furnace is needed in the cohesive zone model of Baogang.
寶鋼軟熔帶模型對高爐監測裝置要求較高；
The three-dimensional progressive damage analysis(PDA) and the cohesive zone model(CZM) are used to simulate respectively the damage progression in laminated composites and that in the adhesive layer.
該方法應用三維漸進損傷分析（PDA）方法和粘聚區模型（CZM）分別模擬復合材料層合板和修補膠層的失效過程。

粘聚區模型
The cohesive zone model (CZM) is used to simulate damage evolution of adhesive material between the notched composite laminate and the patched reinforcement structure. Good agreement is got between the numerical and the experimental results.
針對復合材料層合板開口區補片補強結構,采用各向異性材料連續介質損傷力學方法對復合材料層合板的損傷演化進行描述,采用粘聚區模型對補片與母板間界面材料的分層損傷進行模擬,建立了復合材料開口區補片補強結構三維非線性漸進損傷模型,模型可預測補強結構強度和損傷演化過程。
物理學
內聚力模型