amount of substance
基本解釋
- 物質的量
英漢例句
- The units of temperature, pressure, and amount of substance cancelled out.
溫度、壓力和物質的量的單位相消。 - Lastly, the multi-meaning during the teaching of 'amount of substance' was analyzed.
最后,分析了“物質的量”在教學中的多重意義。 - With the benefit of XRD, the influences of the ratio of the amount of substance of potassium and niobium, reaction temperature and time on the crystal phase and granularity were analyzed.
借助XRD分析了鉀鈮物質的量比、反應溫度和反應時間對晶相和粒度的影響; - A BTU is the amount of heat energy needed to raise the temperature of about one-half kilogram of a substance by one degree Fahrenheit.
- a small amount of fertilizer and dolomite, a powder-like substance made from limestone.
雙語例句
原聲例句
詞組短語
- the amount of substance 物質的量
- amount of a substance 物質的量
- concentration for amount of substance 物質的量濃度
- surface excess amount of substance 表面過剩物質的量
- amount of particles of substance 物質微粒量
短語
英英字典
- a measure of the number of entities (atoms, molecules, ions, electrons, etc) present in a substance, expressed in moles
柯林斯英英字典
專業釋義
- 物質的量
In order to obtain the best condition, bulk polymerization isfirstly carried on the study of the functional monomer, crosslinker,initiator andreaction conditions on the preparation and performance of MIPs by the single factorand orthogonal experiment, the superior condition is that Theα-Methyl Acrylic Acidis used as a functional monomer, Ethylene Glycol Dimethacrylate is used ascrosslinking agent, the ratio is 1:4:20, chloroform is used as a solvent,2,2'-Azobisisobutyronitrile is used as initiator, the amountis 60mg, reactivetemperature is 60℃, L-tyrosine molecularly imprinted polymers (MIPs) of goodadsorption properties can be produced, the extraction efficiencies is as high as 86.57%,saturation adsorption is as high as 77.66μmol/g. Then molecularly imprinted polymer in the aqueous suspension system iscomparatively studied, its optimal reaction conditions: Mixing speed is 200r/min, theratio of amount of substance among L-Tyr, MAA, EDMA is 1:4:20, the amount ofAIBN is 6.0g, 60℃water bathing,by this, L-tyrosine imprinted polymermicrospheres (MIMs)polymerization in relatively small average size (61μm) canbe produced.
為了得到最優合成條件,首先采取本體聚合法制備L-酪氨酸分子印跡聚合物(MIPs),通過單因素實驗和正交實驗,研究了功能單體、交聯劑、引發劑及反應條件對制備MIPs及其性能的影響,得出最優條件為:α-甲基丙烯酸(MAA)為功能單體,二甲基丙烯酸乙二醇酯(EDMA)為交聯劑,其物質的量之比為1:4:20,以氯仿作為溶劑,偶氮二異丁腈(AIBN)作為引發劑,用量為60mg時采用60℃加熱聚合的方法,制備吸附性能良好的L-酪氨酸的印跡分子聚合物MIPs,其萃取效率高達86.57%,飽和吸附量高達77.66μmol/g。物理學
- 物質量
- 實質數量