SerialPort

常見例句

• Specifies the parity bit for a SerialPort object.
  指定SerialPort對象的奇偶校驗位。
• Specifies the number of stop bits used on the SerialPort object.
  指定在SerialPort對象上使用的停止位的數目。
• Represents the method that will handle the serial pin changed event of a SerialPort object.
  表示將處理SerialPort對象的串行管腳更改事件的方法。
• Specifies the control protocol used in establishing a serial port communication for a SerialPort object.
  指定為SerialPort對象建立串行端口通信時使用的控制協議。
• Because the SerialPort class buffers data, and the stream contained in the BaseStream property does not, the two might conflict about how many bytes are available to read.
  由于SerialPort類會緩沖數據,而BaseStream屬性內包含的流則不緩沖數據,因此二者在可讀字節數量上可能會不一致。
• The following code example demonstrates the use of the SerialPort class to allow two users to chat from two separate computers connected by a null modem cable.
  下面的代碼示例演示如何使用SerialPort類以允許兩位用戶分別在兩臺通過NULL調制解調器電纜連接的獨立計算機上聊天。
返回 SerialPort